"Banging on a 2900"
Work Session Status Week Ending 07/13/2013
July 15, 2013
With the #1 driver air brake slack adjuster completed attention is turned to the one trailing truck slack adjuster
which was stolen last year.
Parts for the slack adjuster and cab supports are being cut for later welding and assembly.
The hot water boiler feed pump supply piping work continues as well as interior cab painting, flexible staybolt
plug removal, misc. parts cleaning, painting and sheet metal work.
Planing of the wood planks for the cab floor has begun which has revealed the attractive appearance of the wood.
The boards, when finished, will be installed closer to the end of the restoration.
The two nominees for the Board of Directors were confirmed. Congratulations to Bob DeGroft and Gail Kirby for
Be sure to visit the website to see our Photo Gallery of all that's going on. Rich B. has done a great job in
revamping the website! Take a look at it if you haven't gone there lately.
See you on site this week, and as usual . . .
Keep on Steamin',
Rick Kirby, CMO